Instructions For Use; Maintenance Instructions; Cleaning, Maintaining, Lubricating, Sharpening; Repair Service - stayer FH230 Manual De Instrucciones

4.4.

Instructions for use

Exercise caution when cutting slots in structural
walls; see Section "Information on Structures ".
Clamp the workpiece if it does not remain stationary
due to its own weight.
Do not strain the machine so heavily that it comes to
a standstill.
Grinding and cutting discs become very hot while
working; do not touch until they have cooled.
Rough Grinding
Never use a cutting disc for roughing.
The best roughing results are achieved when setting the
machine at an angle of 30° to 40°. Move the machine
back and forth with moderate pressure. In this manner,
the workpiece will not become too hot, does not discolour
and no grooves are formed.
Flap Disc
With the flap disc (accessory), curved surfaces and
profiles can be worked. Flap discs have a considerably
higher service life, lower noise levels and lower sanding
temperatures than conventional sanding sheets.
Cutting Metal
For cutting metal, always work with the protection
guard for cutting 7.
When cutting, work with moderate feed, adapted to the
material being cut. Do not exert pressure onto the cutting
disc, tilt or oscillate the machine.
Do not reduce the speed of running down cutting discs by
applying sideward pressure.
The machine must always work
in an up-grinding motion.
Otherwise, the danger exists of
it being pushed uncontrolled out
of the cut.
When cutting profiles and
square bar, it is best
to start at the smallest cross
section.
The machine may be used only for dry
cutting/grinding.
For cutting stone, it is best to use a diamond cutting disc.
As a safety measure against jamming, the cutting guide
with dust extraction protection guard must be used.
Operate the machine only with dust extraction and
additionally wear a dust protection mask. The vacuum
cleaner must be approved for the extraction of masonry
dust. STAYER provides suitable vacuum cleaners and
suction casing.
ENGLISH
19

5. Maintenance instructions

5.1. Cleaning, maintaining, lubricating,
sharpening
Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
In extreme working conditions, conductive dust can
accumulate in the interior of the machine when
working with metal. The protective insulation of the
machine can be degraded. The use of a stationary
extraction system is recommended in such cases as
well as frequently blowing out the ventilation slots
and installing a residual current device (RCD).
Please store and handle the accessory(-ies) carefully.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.

5.2. Repair service

The technical service will provide you advice regarding
questions you may have on the repair and maintenance of
your product as well as on spare parts. You may also
obtain exploded views and information on spare parts on
the internet under: info@grupostayer.com
Our team of technical advisors will be glad to guide you
regarding acquisition, application and adjustment of
products and accessories.

5.3. Guarantee

Guarantee card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You should
fill out the card completely and return to vendor with a copy
of purchasing receipt or invoice and you should receive a
receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your
supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
19
Switch on the machine and place
the front part of the cutting guide
on the workpiece.
Slide the machine with moderate
feed, adapted to the material to
be worked.