MCS Master BC 120 Manual De Instrucciones página 11

►►3. ASSEMBLY
The device is equipped with wheels to fa-
cilitate handling. Depending on the model,
wheels can be found already installed or
not. Components equipped with relative
nuts and bolts are found inside the pack-
aging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the "INFOR-
MATION REGARDING SAFETY", before
switching the appliance on.
WARNING: Only use clean water to pre-
vent failures or other anomalies.
WARNING: Verify if your electronic sys-
tem is earthed correctly. Connection to
the mains must be made in compliance
with the National Standards in force. Only
power the appliance the with voltage and
frequency as specified on the nameplate.
NOTE: These models can be connected
to the water mains, by connecting the
pipe to the fitting (Fig. 10).
►►4.1. SWITCH-ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3), the
water level must be between MIN and
MAX of the graduated scale (Fig. 4), so
as to avoid risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
►4.1.5. Press the "ON/OFF"/"POWER"
button to switch on the appliance (Fig. 9).
►►4.2.1. CONTROL PANEL AND
FUNCTIONS (Fig. 7):
►ON/OFF: Turns on or off the device.
►SPEED: Increases or decreases the
ventilation speed of the device. You can
choose from three speeds.
►COOL: Enables or disables the cooling
mode.
►SWING: Enables or disables the auto-
matic swing of the fins to direct the air
flow.
►TIMER: Enables to activate or deacti-
vate the delayed switch-on or switch-off
mode.
-Delayed switch-on: When the cooler is
on, press the "TIMER" button repeat-
edly until the desired time is displayed
(the number flashes), then switch off the
equipment.
-Delayed switch-off: When the cooler is
on, press the "TIMER" button repeatedly
until the desired time is displayed, then
the switch-off time is set.
NOTE: When the cooler emits an
acoustic beep, it means that the tank
is empty and must be filled again
("COOL" function). To deactivate the
acoustic beep, deactivate the "COOL"
function.
►►4.2.2. REMOTE CONTROL AND
FUNCTIONS (Fig. 8):
►POWER: Turns on or off the device.
►LOW - MID - HIGH: Increases or de-
creases the ventilation speed of the de-
vice. You can choose from three speeds:
LOW, MID and HIGH.
►COOL: Enables the cooling mode.
►WIND: Enables the ventilation mode
ONLY.
►SWING: Enables or disables the auto-
matic swing of the fins to direct the air
flow.
►TIMER: Enables to activate or deacti-
vate the delayed switch-on or switch-off
mode.
-Delayed switch-on: When the cooler is
on, press the "TIMER" button repeat-
edly until the desired time is displayed
(the number flashes), then switch off the
equipment.
-Delayed switch-off: When the cooler is
on, press the "TIMER" button repeatedly
until the desired time is displayed, then
the switch-off time is set.
►►4.3. SWITCH-OFF:
►4.3.1. Press the "ON/OFF"/"POWER"
button to switch off the appliance (Fig. 9).
►4.3.2. Drain the tank through the specific
drain plug (Fig. 11-12-13).
en