Troubleshooting - MCS Master BC 120 Manual De Instrucciones

►►7. TROUBLESHOOTING
FAULT
The display does 1. No power supply
not work
2. Defective equipment
There is no air 1. Rear side air vent clogged
flow or it is very
low
2. Defective equipment
The device does 1. Defective equipment
not respond to
the commands
The device leaks 1. The drainage plug is loose
water 2. The drain is dirty and the
3. The tank leaks
4. The panel is dripping
CAUSE
drainage plug does not fully
close
SOLUTION
1a. Make sure that the device is con-
nected to the power supply
1b. Contact a support centre
2. Contact a support centre
1a. Keep the rear of the equipment
away from walls that may obstruct
the airflow
1b. Remove any objects from the air
vent
1c. Contact a support centre
2. Contact a support centre
1. Contact a support centre
1. Close the plug
2. Clean the drain and close the plug
3. Contact a support centre
4. Contact a support centre
en