Environmental Protection - Bosch ZF 60 Instrucciones De Servicio

Cutting
The markings D.C.B.A.0.A.B.C.D on the right adjustment knob 4 are the
settings for the board thickness 9, 12, 16, 19, 22, 25, 28, 32 and 35 mm.
When adjusted correctly, the dowel holes are exactly in the middle and
the joint fits without offset.
G
d(mm)
D C B A 0 A B C D
d
d(mm)
D C B A 0 A B C D
d
2 609 931 304 • 03.12
Example of a corner joint
The boards are clamped as described in Fig. F. Loosen both clamping
levers 11. Proceed as follows for a board thickness of 16 mm:
Figure
– Turn adjustment knob 4 starting from position "0" counter-clockwise
to position "B". Template 12 moves to the rear.
Lock locking lever 11. Place router to the front contours of the tem-
D C B A 0 A B C D plate 12 and cut the dowel holes into the vertically clamped board.
– Turn adjustment knob 4 clockwise via position "0" to position "B" and
lock locking lever 11. Place router to the rear contours of the tem-
plate 12 and cut the dowel holes into the horizontally clamped board.
Shelf joint
For these joints the boards must
be individually clamped and ma-
chined. Align subsidiary line on the
(long) board on the inner edge A
of the template. This line is identi-
cal with the centre of the dowel
holes.
( )
D C B A 0 A B C D

Environmental Protection

The plastic components are labelled for categorized recycling.
Subject to change
English - 7
upper figure
G
Recycling raw materials instead of waste disposal
Machine, accessories and packaging should be sorted for
environment-friendly recycling.
These instructions are printed on recycled paper manufac-
tured without chlorine.
A