Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
APPENDIX C. Heat emission and current draw tables
Modelo / Model
E-8T
E-12T
Modelo / Model
E-8T
70 V or 100 V
E-12T
70 V or 100 V
APPENDIX D. Troubleshooting
The Power Switch is in the On position but the Power
LED indicators do not light up.
The Power LED indicator lights up and the rest of LEDs
do not.
The protection LEDs light up permanently.
"Power ON" LEDs light up but the "Signal" LEDs do not.
One or two Clip LEDs light up with no signal.
Excessive 'Hum'.
Consumos eléctricos (A) / Power consumtion (A)
Carga / Load
70 V or 100 V
70 V or 100 V
Emisión de Calor (BTU/h-kcal/h) / Heat Emission (BTU/h-kcal/h)
Carga / Load
Max
1380 / 350
1795 / 450
Allow the amplifier to cool down. The cause might be
overloading. Turn Off the amplifier, wait a few minutes
the speakers.
/ energy /
Manual del Usuario
Potencia de salida / Output Power
Max
1/3
1/8
5,6
1,7
0,7
7,7
2,4
0,9
Potencia de salida / Output Power
1/3
1/8
445 / 110
235 / 60
510 / 130
235 / 60
The fuse blows, take the unit to a service centre.
The thermal protection
of the transformer is working.
prolonged overloading.
The amplifier might have suffered a momentary
and turn it On again.
Check that there isn't any short circuit in the wires or
Unplug the loads, turn the amplifier Off and, after waiting
a few minutes, turn it On again. If the amplifier does not
work properly take the unit to a service centre.
Check the signal cable and replace if defective.
Check the loads for a short circuit in the cables or the
speakers.
All the electronic equipments must be connected to the
same earth connection. Check all the wires for faulty
shielding. Balanced lines are highly advisable. If posssible do
not connect the sound equipment to the same mains phase
as lights' equipment. Prevent signal wires from running close
to electromagnetic sources like lighting equipment and
others.
User's Manual
Sin señal / Idle
0,3
0,4
Sin señal / Idle
210 / 55
210 / 55
9
EN
Publicidad
Tabla de contenido
