Expobar Brilliance Manual De Usuario página 38

• Technical programming
The next three parameter set the hot water coming out from the hot water spout. This water will not
be mixed with any soluble. Here we can set the "Pause Water2" and the "Time2Water2" to 0. With
"Enter" we will accept the different settings and proceed to following
Enter
Time 1 Water 2
Key 1 #.# s.
Canc
Enter
Pausa Water 2
Key 1 #.# s.
Canc
Time 2 Water 2
Key 1 #.# s.
Canc
Enter
Now we will set the times for the mixer (Mixer Time 1). This time setting, adjusts how long will
the mixer run while receiving the water and the powder. With buttons "+" and "-" we adjust the
time; with "enter" we accept the setting, and proceed to the next adjustment
Enter
Mixer time 1
Key 1 #.# s.
Canc
Enter
The following parameter (Mixer time 2) is not used in this machine (let it as 0).
Now it comes the adjusting of the soluble ingredients. The quantity of soluble powder that will be
added to the actual recipe. Two canisters are available. Soluble time 3&4 are not used in this
machine: keep them set to 0. Each amount of product is set by increasing (pressing "+") or
decreasing (pressing "-") the time during which the soluble is added.
Enter
Soluble Time 1
Key 1 #.# s.
Canc
Enter
Soluble Time 2
Key 1 #.# s.
Canc
Enter
Finally we have to set the delay with which the solubles will be brewed. With buttons "+" and "-"
adjust the desired value; with "enter" we would begin adjusting parameters of button "2". With
"Canc" we would come back to the superior menu.
Enter
Canc
Soluble Delay
Key 1 #.# s.
Enter
English
Water2
Time 1 Water 2 Pause Water 2
Mixer Time 1
Soluble time 1
Soluble Delay
36
Time 2 Water2
Canc
Canc
Soluble time2
Soluble Time 3
Key 1 #.#
Enter
Soluble Time 4
Key 1 #.# s.
Enter