Ipod And Iphone (X-Em21 Only); Cautions On Use; When Moving This Unit; Place Of Installation - Pioneer X-EM21 Manual De Instrucciones

10 Additional information
Problem
Clock/timer setting is erased.

iPod and iPhone (X-EM21 only)

Problem
No sound is produced.
iPod or iPhone will not charge.
"This accessory is not made to work with
iPhone" or "This accessory is not
supported by iPhone" appears on iPhone
screen.

Cautions on use

When moving this unit

When moving this unit, be sure to first check that there is no
disc loaded and disconnect the iPod/iPhone. Then press
 STANDBY/ON, wait until [GOOD BYE] disappears on
main display to turn off, and then unplug the power cord.
Damage may occur if the unit is transported or moved with a
disc inserted, or when another device is connected to the
iPod/iPhone connector port, USB terminal, or AUX IN mini-
plug jack.

Place of installation

• Choose a stable place near the TV or stereo system being
used with this unit.
• Do not place this unit on top of a TV or color monitor.
Also, install it away from cassette decks and other
devices easily affected by magnetic forces.
Avoid the following locations:
• Places exposed to direct sunlight
• Humid or poorly ventilated places
• Extremely hot places
• Places exposed to vibrations
• Places in which there is much dust or cigarette smoke
• Places exposed to soot, steam, or heat (kitchens, etc.)
24
En
Solution
Power has been interrupted or the AC power cord has been disconnected.
Reset the clock/timer.
Solution
The iPod or iPhone is not playing.
The iPod or iPhone is not properly connected to the unit.
Is the AC power cord of the unit plugged in?
Audio from the iPod/iPhone cannot be heard via the headphones connected to the unit.
The iPod or iPhone is not making full contact with the connector.
The iPod or iPhone is not supported. Refer to page 16 for compatible models.
The iPhone battery is low. Please charge the iPhone.
iPhone is not properly docked.

Do not place objects on this unit

Do not place any objects on top of this unit.
Do not obstruct the ventilation holes.
Do not use this unit on shaggy rugs, beds, sofas, etc., or
wrapped in cloth, etc. Doing so will prevent the heat from
dispersing, leading to damage.
Do not expose to heat.
Do not place this unit on top of an amplifier or other
components that generate heat. When rack mounting it, to
avoid the heat given off by the amplifier or other audio
components, place it on a shelf below the amplifier.
• Turn off the power of this unit when not using it.
• Depending on signal conditions, striped patterns may
appear on a TV screen and noise may enter the sound of
radio broadcasts when the power of this unit is on. If this
happens, turn off the power of this unit.