Product Description - Gaymar Medi-Temp III FW600 Blood/Fluid Warmer Serie Manual Del Operador

SETPOINT switch
button
RUN /STANDBY
switch
Cassette slot

2.0 Product Description

The Medi-Temp III FW600 Series Blood/Fluid Warmer
is a dry-heat device designed for safe and rapid
warming of blood, blood products and other fluids
through the utilization of disposable blood/fluid
warming sets. The warmer does not provide fluid flow
rate control. Blood, blood products and other fluids
normally refrigerated, can be rapidly warmed to user
selectable temperatures of between 38.0°C–43.0°C
at flow rates up to 300 ml/min. Room temperature
fluids can be warmed at flow rates up to 500 ml/min.
The disposable Blood/Fluid warming sets are available
in Standard, Standard with Extensions, Pediatric, and
High Flow models.
2.1 Warmer
The warming unit is designed to be IV pole
mounted. The device has no on/off switch.
Connection to the AC supply is indicated by a
green STANDBY mode indicator, located on the
front panel. In STANDBY mode, no power can be
applied to the heater. To begin normal operation,
the RUN/STANDBY button must be pressed.
2
ENGLISH
Figure 1—FW600 series Blood/Fluid Warmer
When this occurs, an LED temperature display located
on the front panel will display the actual fluid
temperature or the setpoint temperature in °C.
The setpoint is user selectable from 38.0°C–43.0°C
in 1.0°C increments, by use of the SETPOINT switch on
the front panel. Also located on the front of the unit is
a slot for insertion of the disposable warming set. On
the right side of the unit, just below the IV pole clamp,
is a receiver for the disposable warming set's bubble
trap.
2.2 Disposable sets
The Medi-Temp III FW600 Series Blood/Fluid warming
unit is designed to be used only with Gaymar D25000
series disposable warming sets. The following warming
sets (figure 2) are designed for use up to 300 mm Hg
pressure. Contact your local dealer for more
information.
REMOVE FROM USE
indicator
STANDBY
indicator
IV pole clamp
Bubble trap
receiver