Cleaning And Maintenance - cecotec CONGA 1990 CONNECTED Manual De Instrucciones

ENGLISH
Cancelling scheduled cleaning
Press the schedule button on the remote control, select the day you wish to delete and change
the set time to 00:00 am., this is the time to be set to cancel the cleaning programme. Fig. 39.

4. CLEANING AND MAINTENANCE

In order to lengthen your robot's shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
- Empty the robot's dust tank.
- Press the dust tank's release button. Fig. 40
- Open the dust tank and empty it. Fig. 41
Robot filter cleaning
- Remove the filter.
- Carefully shake off all dust from the filter. Fig. 42
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning
Do not spray cleaning products directly on the sensor. Fig. 43
Main brush cleaning
-
Slightly press the main brush frame's tabs in order to open the main brush storage
compartment and to remove it. Fig. 44
- Remove any hair, fluffs or dust collected in the brush and around the axes. Fig. 45
- Clear and clean the robot's suction channel. Fig. 46
- Reinstall the main brush and its frame. Fig. 47
High-efficiency filter
- The high-efficiency filter is designed with fibres that help trapping dust particles, dust
mites, pollen... It is very important to clean periodically the filter, to avoid this particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
- It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
48
05660_Conga 1990 Connected_IM_YV_0121085.indd 48 05660_Conga 1990 Connected_IM_YV_0121085.indd 48 6/8/21 13:08 6/8/21 13:08