30" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
Bridge Style Burners (some models)
Install Burner Caps, these include one Bridge Burner
Center Cap (rectangular shaped) and the two Bridge
Burner End Caps (The Bridge Burner End Caps will fit
either the front or
rear Bridge Burner
Head locations).
Make sure that
Bridge
the lips located
Burner
under the Bridge
End
Burner Caps fall
Cap
into the slots
located in the
Bridge
Bridge Burner
Burner
Head (See arrows
Center
in Figure 15) and
Cap
that all the Bridge
Burner Caps lie
flat and evenly on
Bridge
the Bridge Burner
Burner
Head.
End
Cap
Double Ring Style Burners (some models)
The Double Ring burner only operates properly with
two burner caps in place. Be sure the burner cap lips are
positioned facing down towards the burner head (Figure
16) and into the recessed areas (Figure 17) on each side
of the burner head. Be sure both burner caps are seated
firmly and rest level on the burner head before operating.
Check the fit for each cap using the same method for the
round burner caps by gently sliding each cap from side to
side. Please note that the burner cap lips should NOT move
out of recessed areas of the burner head.
Burner
Caps
Recessed
area
Burner
Head
(Model with Electric Oven and Gas Cooktop)
Bridge Burner Head
Igniter
Hole
Igniter
Hole
Fig. 15
Fig. 16
Fig. 17
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
a. Push in and turn a surface burner knob to the
LITE position. All electronic surface ignitors
will spark at the same time. However, only the
burner you are turning on will ignite.
b. The surface burner should light once the flow
of gas reached the surface burner. Each burner
should light within four (4) seconds in normal
operation after air has been purged from supply
lines. Visually check that burner has lit.
c.
Once the burner lights, the control knob should
be rotated out of the LITE position.
There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
4. Adjust the "LOW" Setting of Regular Surface
Burner Valves (Figure 18):
a. Push in and turn control to LITE until burner ignites.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame
size can be increased or decreased by turning the
screw. Turn counterclockwise to increase flame size.
Turn clockwise to decrease flame size. Adjust flame
until you can quickly turn knob from LITE to LOWEST
POSITION without extinguishing the flame. Flame
should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface
burners.
9
Figure 18