Adapting Microwave Blower For Outside Back Exhaust - GE CVM521P2MS1 Instrucciones De Instalación

To use toggle bolts:
Mounting
Bolt
Wall
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
centered under the cabinet.
CAUTION Be careful to avoid pinching
fingers between the back of
the mounting plate and the wall.
4
to help tighten the bolts.
B3. USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Drill the holes, following the instructions on the
Wear safety goggles when
CAUTION
drilling holes in the cabinet
bottom.
Installation Instructions
Bolt End
B4. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
1 Remove and save screws
motor to microwave oven.
2
the microwave. Remove and save the blower shield
Remove and save the metal vent fan cover on the
3
blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
4 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave Oven
that holds blower
Blower Retaining
Screws
Back of Microwave Oven
End B
After Rotation
Back of
Microwave Oven
17