Loewe 50470 Serie Instrucciones De Montaje página 9

Installation
The enclosed instructions show / refer to fi xing to vertical brick or concrete walls.
The person installing the TV is responsible for assessing the load bearing capacity of the wall and the fastening of
the wall holder.
Because of the potentially different wall building materials and fastening parts needed in conjunction with these, we have not
included any fastening parts. Please buy suitable fastening parts for your wall from a dealer.
Consult a building expert if necessary.
Make sure that there are no cables / pipes near to where you drill the holes.
See the diagrams on pages 16 to 20 (installation diagram folding out to the right in the instructions).
Installation of the Wall Mount Reference
Prepare wall holder for installation
Please study the drawings on pages 16 to 20.
- Remove wall holder from its packaging
- Check that the delivery is complete
- Lock gas shock absorber into place and secure by pushing in the spring band, see page 16, fi g. 2, fi g. 3, fi g. 4.
- Remove the adjusting screws from the separate pack and screw them into the wall holder, see page 17, fi g. 5, arrow S.
(the unit can be precisely adjusted on the wall using these adjusting screws)
Page 20, Fig. 12 shows dimensional data helpful for positioning the wall holder.
Note the installation height from the ground (155 and 135 cm) suggested in the diagram.
Fasten wall plate and wall holder
We recommend getting another (second) person to help.
Select the fastening location and check that there are no cables or pipes concealed in the wall beneath it.
Use the wall plate as a template for marking the drill holes.
Recommended procedure
- Hold the wall holder where it is to be fastened
- Align the wall plate on the wall with the help of a spirit level
- Mark the holes on the wall through the opening in the wall plate
- Drill holes corresponding to your fastening material
In the example, this is 6 holes for plug diameter 12 x 60 mm and screws of diameter 8 x 70/ 10 x 70 mm, page 17, Fig. 5, arrows
A and B.
Insert the fastening material you have purchased and screw the wall plate and wall holder tightly to the wall.
Install fastening adapter on the TV set
If your TV set is already installed on a fl oor stand, remove the TV set from the fl oor stand.
Remove the two fastening screws, lift off TV set and set aside on a suitably prepared surface.
See page 17, Figs. 6, Figs. 7 and 8.
Further procedure
Remove fastening adapter from the wall holder.
- Loosen the two upper fastening screws (only slightly)
- remove the lower fastening screw
Unhook the fastening adapter on the wall holder and install this on the TV set, as shown in Fig. 8.
Fastening adapter and TV set on the wall holder
Get another person to help you hook in the TV set on the expanded wall holder (page 18, fi g. 9, page 19, fi g. 10).
Screw in the fastening screw you removed previously (page 18/ 19, Fig. 9/ 10, arrow).
If necessary, you can adjust the TV set slightly in the horizontal position.
Tighten the 3 screws used to fasten the fastening adapter to the wall holder (torque approx. 5 Nm).
You can lay the connecting cable in the braided hose (page 19, fi g. 11). To do this, fold the TV set on the wall holder away from
the wall. Connect the connecting cables as described in the TV operating manual.
9