EYENIMAL CLASSIC dog Fence Manual De Instrucciones página 6

● Switching On/Off the transmitter
▪
Switch the transmitter On using the On/Off switch located on the left side of the transmitter. The green indicator light will come on
(cf. Diagram 1).
▪
Switch the transmitter Off using the On/Off switch located on the left side of the transmitter. The green indicator light will go out (cf.
Diagram 1).
● Activate/deactivate the CLASSIC DOG FENCE receiver collar
▪
Activate: connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter and into a wall
outlet. The green indicator light on the transmitter comes on, the transmitter is On.
▪
Deactivate: disconnect the AC adapter from the wall outlet. The green indicator light on the transmitter goes out, the transmitter is
Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire break alarm
would alert you to a connexion default (ref. § Safety features – wire break alarm).
● Fitting the battery in the receiver collar
 Unscrew the 4 screws of the battery cover using a screwdriver.
 Insert the battery (3V Lithium CR2) paying attention to follow
polarity indicated on the battery housing.
 A beep sound is emitted indicating the correct installation of the
battery. If you do not hear any beep sound after having inserted
the battery, remove it immediately from its housing. Check the
polarity before trying again.
 Before putting the lid back in place, check that the rubber seal is
in its groove.
 Retighten moderately the 4 screws.
● Activate/deactivate the receiver collar
The supplied magnetic key allows you to activate/deactivate the collar.
▪ Activate: move the magnetic key towards the collar so that it comes into contact with the
located on the collar, hold for 1 second (ref. Diagram 6). The collar will emit one beep sound and the
indicator light will flash in green indicating the collar is On.
▪ Deactivate: move the magnetic key towards the collar so that it comes into contact with the
symbol located on the collar, hold for 1 second (ref. Diagram 6). The collar will emit two beep sounds
and the indicator light will flash in red then go out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long
period.
If your
dog needs to leave the authorized area, you have to remove the collar or deactivate the transmitter by disconnecting it
from the power supply.
Battery polarity indicators
- 4 -
Diagram 5
Battery
Seal
symbol