Recommended Spare Parts; Troubleshooting - Nilfisk CTS26 Manual De Instrucciones

CTS26 ClassII Div2 Group F, G
Original instructions

Recommended spare parts

The following is a list of spare parts that should be kept ready at hand in order to speed up maintenance operations.
Refer to the manufacturer's spare parts catalog when ordering spare parts.
Description
Star filter kit
Filter ring seal
Filter chamber gasket
Filter clamp
Absolute filter

Troubleshooting

Problem
Clogged primary filter
Clogged vacuum hose
The vacuum cleaner suddenly stops
Circuit breaker activation
US
Dust leaks from the vacuum cleaner The filter is torn
Electrostatic current on the vacuum
Non existent or inefficient grounding
cleaner
The vacuum cleaner does not start
The level monitoring hose is clogged
after emptying the container
C429
Model
Base AU/HEPA AD/ULPA
40000425
40000702
8 17026
40000762
8 18079
- Z8 17455 81778900
Cause Remedy
Shake the filter. Replace it if this is not
sufficient.
Check the vacuum hose and clean it.
Check the setting.
Check the motor electrical input.
Empty the container.
Contact an authorized after-sales
service center if necessary.
Replace it with another of identical
type.
Check all ground connections.
Especially check the connection at the
inlet.
Release the container and clean the
level sensor.
14
WARRANTY
Nilfisk warrants that its equipment will be free of defects in workmanship or material for a period of two years from the date of
delivery. If the vacuum fails to meet these warranty standards, Nilfisk shall, upon notification within such time period, correct
such non-conformity, at its option, either by repairing any defective part or parts, or by replacing a part or parts, provided that the
equipment is returned to an authorized Nilfisk service facility. In all cases freight both ways will be at expense of the customer.
Equipment shall not be returned without advance notice to, and consent of Nilfisk.
EXCEPT AS SPECIFICALLY SET FORTH HEREIN, NILFISK MAKES NO WARRANTIES, EITHER EXPRESSED OR
IMPLIED, AS TO ANY MATTER WHATSOEVER, INCLUDING WITHOUT LIMITATION ANY AND ALL WARRANTIES OF
MERCHANTABILITY, FITNESS OF PURPOSE, OR OTHER WARRANTIES, ALL OF WHICH ARE EXPRESSLY DISCLAIMED
AND EXCLUDED. NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR SPECIAL, INDIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF PRODUCTION, LOSS OF PROFITS OR ANY
OTHER SIMILAR INDIRECT LOSSES WHICH MIGHT OCCUR AS A RESULT OF DEFECTS, PARTIAL OR TOTAL FAILURE
OF THE PRODUCT TO PERFORM AS SPECIFIED.
Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfilment
of all liabilities of Nilfisk to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of
such equipment. The remedies set forth herein are exclusive, and the liability of Nilfisk with respect to this sale or anything done
in connection therewith, whether in contract, in tort, under any warranty, or otherwise, shall not, except as expressly provided
herein, exceed the price of the equipment or part on which such liability is based.
This warranty does not cover repairs due to normal wear and tear, accident, neglect, misuse or abuse, incorrect installation or
use other than as described in the instruction booklet. Breaks in hoses and cables are not covered.
This warranty is rendered void if the motor number plate is removed or defaced or if repairs are made or attempted by persons
not authorized by Nilflsk.
Some states do not allow exclusion of implied warranties or limitations on how long an implied warranty lasts so the above
exclusions or limitation of implied warranties may not apply. Some states do not allow exclusion or limitation of incidental or
consequential damages so the above exclusion or limitation of incidental or consequential damages may not apply. Limited
warranties set forth above give specific legal rights. Customer may have other rights which vary from state to state.
DISCLAIMER
The purchaser and intended user of this Nilfisk ClassII Div2 vacuum acknowledge that their Authority Having Jurisdiction (AHJ)
as defined in Article 100 of the National Electric Code (NEC – NFPA 70) has determined this specific type of vacuum equipment
is suitable for use in the intended applications and hazloc rated environments. Nilfisk-Advance, the product manufacturer, is not
an AHJ and cannot approve any particular ClassII Div2 vacuum product for any specific application or use. It is the purchaser's
and the intended user's responsibility to ensure that the vacuum is used properly as described in the instruction manual and in
accordance with the AHJ's approval. By issuing a purchase order, the purchaser and intended user acknowledge understanding
the role of their AHJ along with the capabilities and limitations of the vacuum equipment. If you require assistance in identifying
your AHJ, please contact your local Nilfisk District Manager for assistance.
02/2017 02/2017
CTS26 ClassII Div2 Group F, G
Original instructions
15
US
C429