Putting Into Service - GRE EESB55 Manual De Instrucciones

4. Installation of the vase
The vase must be glued on line (in Ø50 or Ø63)
that runs towards the swimming pool, after the
filter and after the heater or the beginning of the
compressor.
Make sure that there is enough space on the
removable side of the vase to be able to withdraw
the electrode.
Operating:
Front view of the electrolyzer
Do not mount the vase
in this direction.
101452 Installation and user manual
Fixed red led: No production, unit to standby
potentiometer between 0% and 25%. Wait at
least 2 minutes after the standby before
putting the unit into production.
Fixed green led: in production between 25%
and 100%. Use the potentiometer to get the
desired level of chlorine.
blinking red led: Default (See Chapter 7
Electrode calcified)

5. Putting into service

Before any operation, pool's water has to be
crystalline. Use flocculent if necessary and filter
the water then clean your filter.
Stapes to follow for the first start of the device:
a) Turn potentiometer to 100 leaving the filtration
24h/24 until the
(minimum 0.5 ppm) is reach.
b) Put back automatic
potentiometer to 75.
c) Adjust production using the potentiometer
according to the level of chlorine desired.
6. Indoor pools or pools with
covers
If swimming pool water is not exposed to UV rays,
then the chlorine content may become excessive
and therefore corrosive.
It should significantly reduce the production of your
electrolyzer when the pool is covered (minimum
50%).
7. Chlorine analysis method
The analysis should be made at approximately the
same time and the same place (at a point
equidistant between
skimmer). The chlorine produced by your salt
chlorinator is very volatile and the reading of its
content may vary according to different parameters
(UV, number of bathers, organic matter, etc.). If
there are an exceptionally high number of bathers,
then we advise you to switch the filtration to
manual mode in order to compensate for chlorine
deficit.
desired chlorine level
filtration and turn
the backflow and the
14