Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Congratulations for your excellent choice.
Our ash vacuum cleaner is not only a top quality and highly reliable product, but it is also easy to use and offers a safe
and long-lasting operating life.
It has been designed to vacuum only cold ash. It is not suitable for boilers or for fuel oil stoves nor can it be used for
plaster powder or cement dust.
IMPORTANT - Safety warnings - Read carefully before use
-
Do not leave the ash vacuum cleaner plugged in when not in use. Always stop the appliance with the
ON/OFF switch before taking the plug out of the socket.
-
Do not pull the lead.
-
Do not use to vacuum water or other liquids
-
The cover of the motor compartment must only be cleaned with a dry cloth.
-
Do not leave the ash vacuum cleaner outdoors, it must always be kept in a dry place and not where it could
be affected by bad weather conditions.
-
Electric lead : if the electric lead is damaged, it must be replaced by the manufacturer, by the manufacturer's customer
service or by qualified people.
-
This device is not intended for use by people (including children) with limited physical, sensorial or mental
capacities or by people lacking in experience or knowledge unless they are assisted or shown how to use the
appliance by a person responsible for their safety.
HOW TO PREPARE AND USE THE ELECTRIC ASH VACUUM CLEANER
-
Position the appliance on a flat surface.
-
Make sure the filter is fitted in its housing (fig. 1)
-
Connect the steel pipe to its fitting. (fig. 2)
-
Before cleaning the stove make sure that it has cooled down properly. Before vacuuming the ash, check that
it is cold and no longer alight.
-
Plug the electric lead into a socket, making sure the voltage is suitable for the characteristics of the
appliance plense, check the rating label on the appliance.
-
Turn the appliance on using the luminous ON/OFF switch located on the cover of the motor.
-
Vacuum the ash directly from the fireplace or from the stove using the steel pipe.
-
If there should be a reduction in the suction power, turn the motor off using the switch and when the motor
is completely still, operate the lever several times to reset the filter. To do this, pull out the knob fully and
then release it sharply so that it shakes the filter inside the appliance.
-
Now, turn the appliance on once again using the switch.
-
It is advisable, in any case, to clean a max. of 2/3 Kg of ash during each cleaning operation. Operate the
filter reset lever, before each cleaning cycle.
-
When the stove or fireplace has been cleaned, the appliance and suction filter must then be cleaned (this
operation must be carried out outside the house).
-
Position the steel pipe in fitting (fig.3) and turn the appliance on using the switch. Direct the outlet of air
towards the filter and, if necessary, shake the filter with the metal nozzle located on the outside of the pipe.
-
Once the filter has been cleaned, check whether it is suitable for further use. If it has been damaged or
broken, replace it with an original Ribimex filter.
www.sidirika-nikolaidi.gr
Publicidad
