Styling - Curling; Cleaning And Care - Silvercrest SBHS 50 B1 Instrucciones De Uso

Styling – curling
For styling, the hair should be dry or slightly damp and free of styling products.
This does not apply to products that protect the hair from the effects of heat.
The appliance is heated up to the desired level and the hair is combed and free
of knots.
Twist the end of the strand around the styling brush 2 and then roll the
■
styling brush 2 upwards towards the hair roots so that the complete strand
is rolled around the styling brush 2. Ensure that you touch the appliance
only on the holding tip 1 and the handle. The styling brush 2 gets very hot.
■ Wait for 8 –15 seconds (depending on the length and thickness of the hair).
Press the curl release button 3 and simultaneously pull the appliance out of
■
the strand in a downwards direction. The styling brush 2 turns so that the
strand can be unrolled easily.
■ Proceed the same way with the other strands.
Once you are finished styling, turn the level switch 6 to "0" and pull out the
■
plug from the mains power socket.

Cleaning and care

RISK OF ELECTRIC SHOCK
► Before cleaning the appliance, always pull out the plug from the mains
power socket. There is a risk of electric shock!
WARNING! RISK OF INJURY!
► Allow the appliance to cool fully before cleaning it. Risk of burns!
CAUTION! PROPERTY DAMAGE!
► Do not use any aggressive, abrasive or chemical cleaning agents!
These could damage the upper surfaces of the appliance.
Remove any hair or lint from the bristles of the styling brush 2 with your
■
fingers.
■ Clean the appliance only with a lightly moistened cloth.
■ Allow the appliance to dry completely before reuse or before putting it away.
SBHS 50 B1
GB │ MT │
45 ■