Removing Attachments; Switching On/Off / Selecting A Heat Level; Styling - Silvercrest SWC 300 C1 Instrucciones De Uso

Removing attachments

■ First switch the appliance off and allow it to cool down.
■ Pull the attachment from the attachment insertion slot
Switching on/off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch
– "0"
– "C"
– "1"
– "2"
■ You switch the appliance off by sliding the level switch
(= appliance off).
■ To fix the styling, you can move the level switch
fixed by the cool air stream.

Styling

Select the desired attachment:
–
for long hair and large curls the large styling brush
–
for shorter hair or small curls the small styling brush
■ Wind the slightly damp strand of hair around the selected styling brush
■ Switch the appliance on at level 1 or 2.
■ When the strand is dry, slide the level switch
has cooled.
■ Press the roll-out button
out of the strand. The styling brush
the strand can be done easily.
■ Proceed with the other strands in the same way.
■ 44 │ GB │ MT
and select the output level:
The appliance is switched off
for a cold air stream (Cool Shot)
for a warm air stream
for a hot air stream
and simultaneously pull the appliance downwards
.
to the position "0"
to "C". The styling will be
.
.
to "C". Wait until the strand
/ rotates with it, so that unwinding
/ .
SWC 300 C1