Troubleshooting - Clatronic KA 3509 Instrucciones De Servicio

Leaving the
setting mode:
Wait ca. 15 seconds after the last push
of a button. The notification "TIMER" in
the display will disappear.
9. Press the ON/AUTO/OFF button twice to start the TIMER
operation. The AUTO indicator lamp lights up green.
NOTE:
• The appliance swiches on automatically at the preset
time. The AUTO indicator lamp turns off and the
RUN indicator lamp lights up.
Press the ON/AUTO/OFF button once to deactivate
•
TIMER operation.
• Once both indicator lamps are off, the device is
switched off.
• If you would like to start the brewing process sooner,
press the ON/AUTO/OFF button twice. The RUN
indicator lamp lights up red.
The Coffee Is Ready
NOTE:
The brewing process lasts approximately. 10-15 minutes.
• When no more coffee is flowing through the filter you can
remove the pot.
• Turn the device off.
• Would you like to keep the remaining coffee warm? Leave
the machine switched on until the pot is empty.
NOTE:
The filter holder can be removed from the machine by its
handle. This makes it easier to dispose of the old coffee filter,
for example.
De-scaling
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acidbased de-scaler.
• Follow the recommended instructions for use.
WARNING:
• Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
• Do not use any coffee powder!
Do not use this water for consumption.
•
Cleaning
WARNING:
• Before cleaning, always remove the mains plug and wait
until the device has cooled down.
• Do not immerse the device in water. Otherwise this might
result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
• Remove spilled coffee grounds with a paper towel from the
inner casing. Afterwards wipe with a damp cloth.
• The coffee pot and the filter pad should be cleaned by rins-
ing in warm water. Use a soft brush if necessary.
Storage
• Clean the appliance as described and let it dry completely.
• For longer periods of non-use we recommend storing the
appliance in its original packaging.
• Always store the appliance in a well-ventilated and dry
place out of reach of children.

Troubleshooting

Problem Possible cause
The appliance The appliance is
does not work. not connected to
mains power.
The appliance is
defective.
Filter blockage: The drip stop is
coffee grounds closed: The coffee
spill over the pot is not on the
edge of the filter. warming plate or
the lid is not on the
coffee pot.
Too much coffee
powder in the filter.
Coffee grounds The paper filter is
in the coffee. too small.
Too much coffee
powder in the filter.
The brewing Limescale deposits
process takes in the appliance.
too long.
Solution
Check the wall outlet
with a different appli-
ance.
Insert the plug properly
in the wall outlet.
Check the fuse.
Contact our service or
a repair center.
1. Switch the appliance
off. Disconnect from
mains power supply.
2. Put the coffee pot
with lid on the warm-
ing plate so that the
filter is emptied.
3. Dispose of the paper
filter.
4. Clean the appliance
as described.
Use a paper filter size
"1x4".
Use less coffee powder.
Decalcify the appliance
as described.
31