Makita 6096D Manual De Instrucciones página 5

CAUTION:
• Pressing excessively on the tool will not speed up the
drilling. In fact, this excessive pressure will only serve
to damage the tip of your bit, decrease the tool perfor-
mance and shorten the service life of the tool.
• There is a tremendous force exerted on the tool/bit at
the time of hole breakthrough. Hold the tool firmly and
exert care when the bit begins to break through the
workpiece.
Drilling and driving performance
The following reference table indicates the approximate drilling and driving capacities from a single battery charge. It
may differ under some conditions.
Dimensions
Application
of hole
6.5 mm
Metal
10 mm
Wood *15 mm
*18 mm
Application
Wood screws
(*...350 tr/mn)
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the bat-
tery cartridge is removed before carrying out any work on
the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a
Makita Authorized Service Center.
Workpiece
3 mm
Cold-rolled steel
sheet or plate
3 mm
Aluminun sheet
9 mm
Medium hard wood
Dimensions of
wood screw
3.5 mm x 20 mm
4.5 mm x 20 mm
*5.1 mm x 35 mm
*5.5 mm x 50 mm
• A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back out.
However, the tool may back out abruptly if you do not
hold it firmly.
• Always secure small workpieces in a vise or similar
hold-down device.
• If the tool is operated continuously until the battery car-
tridge has discharged, allow the tool to rest for 15 min-
utes before proceeding with a fresh battery.
Thickness
1.6 mm
1.6 mm
25 mm
Workpiece
Medium hard wood
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Phillips bit
• Slotted bit
• Soket bit
• Drill bit for steel
• Drill bit for wood
• Rubber pad assembly
• Foam polishing pad 125
• Wool bonnet 100
• Battery cover
• Various type of Makita genuine batteries and chargers
No. holes
Battery 9000
230
50
750
120
350
100
60
Fastenings
Battery 9000 Battery 9033
500 screws
400 screws
90 screws
60 screws
Battery 9033
380
80
1,250
200
590
160
100
850 screws
650 screws
150 screws
100 screws
5