Emptying The Dust Container; Accessories; Disposal; Warranty - Festool CLEANTEX CTH 26 E/a Manual De Instrucciones

CTH
GB
NOTE
Motor damage
X Never operate the extractor without a fil-
ter element fitted as the motor may be-
come damaged.
X
Open the locking clips [2-2] and remove
the top section of the machine[2-1].
X
Turn the top section of the machine so
that the main filter [9-1]is facing up-
wards (Fig.[9]).
X
Remove the two safety bolts [9-3]on the
lever [9-4]using a screwdriver.
X Fold over the lever [9-4] and remove the
retainer [9-2]with the main filter.
X
Insert the retainer with the main filter in
the safety bag supplied.
X
Remove the main filter from the retainer.
X Remove the retainer from the safety bag.
X
Close and dispose of the safety bag in ac-
cordance with statutory regulations.
X
Clean any dust deposits from the area be-
hind the main filter.
X Insert a new main filter in the frame.
X
Insert the retainer [9-2]with the main fil-
ter and fold over the lever [9-4] until it
engages in position.
X
Tighten the safety screws[9-3].
X
Replace the top section [2-1] and close
the locking clips [2-2].
9.2

Emptying the dust container

The dust container [2-3] can be emptied
once the top section has been removed.
X
After extracting fluids, clean the fill level
sensors [10-1] regularly with a soft cloth
and inspect for damage.
10

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
22
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers for the accessories and
filters can be found in the Festool catalogue
or on the Internet at "www.festool.com".
10.1 Modules
The following modules for upgrading the mo-
bile dust extractor are available in the acces-
sories programme. Modules must be fitted to
the module slot [1-3] by an authorised ser-
vice workshop:
– Compressed air module,
– Socket module with permanent power sup-
ply,
– Socket module with automatic switch-on
unit (not suitable for GB 110 V version),
– Energy box module (EAA) for using the au-
tomatic switch-on unit on the EAA.
You can find more detailed information on
the modules at "www.festool.com".
11

Disposal

Do not throw the tool in your household
waste!! Dispose of machines, accessories
and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.
EU only: European Directive 2002/96/EC
stipulates that used electric tools must be
collected separately and disposed of at an
environmentally responsible recycling cen-
tre.
12

Warranty

We offer a warranty for material and produc-
tion defects for all our tools in accordance
with the locally applicable legal provisions,
but for a minimum of 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note). Damage caused by the operator,
natural wear, overloading, incorrect handling
or through the use of the equipment not
specified in the operating manual, or damage
which was known at the time of purchase, is
not covered by the warranty. Furthermore,
damage caused by the use of non-original
accessories and consumable materials (e.g.
sanding pads) is also excluded.