Gallagher SmartReader HR3 Manual Del Usuario página 20

Memory Counter
The Memory counter is only applicable when in Memory mode.
Once the memory is full, the Memory counter displays FULL.
Note however that even when the memory is full, if a new
EID tag is read the number of tag reads in the current session
still increases (in the example shown, 28 is the number of tag
reads).
Note: Once the memory is full in Memory mode, each time you read a new EID tag, by
default, the oldest EID tag data is deleted and the newest EID tag data is stored. This
can be changed using the ‘'Overwrite’' setting in Configurator. For further details refer to
the SmartReader HR Configurator Help.
3
The Memory counter is returned to 0 by downloading tag data using MyScale Pro.
For further details refer to the MyScale Pro Help.
Session Limit
The SmartReader has a session limit of 100. While the current
session number cannot be identified, if you reach the session
limit the following screen displays:
If this occurs, you should immediately download the sessions
using MyScale Pro. However, you can continue to read and
store tags to the current session, providing there is sufficient
space within the current session, or it has been configured to
allow this. Refer to the SmartReader HR Configurator Help.
3
Non-Memory mode options
Zero count
Single-Click the trigger to reset the number of tags read in the current session.
Only applicable when in Non-memory mode.
20