HIKOKI CJ 36DA Instrucciones De Manejo página 17

Pocket cutting
Angular cutting
Concerning cutting of stainless steel
plates
Connecting with cleaner
(sold separately)
Charging a USB device from an
electrical outlet
Charging a USB device and battery
from an electrical outlet
How to recharge USB device
When charging of USB device is
completed
Selecting accessories
*1 The tool is equipped with two modes: "Standard Mode"
and "AUTO Mode".
(1) Standard Mode
You can change the blade operating speed between
800 to 3500 min by adjusting the dial from "1" to "5".
-1
(2) AUTO Mode
AUTO Mode automatically selects a speed between
1400 and 3500 min
maintains that speed until the switch is turned off .
This has the eff ect of lowering vibration and noise
prior to and during operation.
Adjust the dial for the mode and speed that best suits
your task conditions and materials.
Blade operating speed
Mode
Standard Mode
AUTO Mode
With AUTO Mode, the vibration frequency may not reach
3500 min depending on variables such as the type of
-1
work.
*2 Sub base
NOTE
When the sub base is attached, the blade's protrusion
from the material being cut will be reduced by 3 mm.
When the blade has been moved down to the lowest
point, check to make sure that it is protruding from the
material.
*3 Switch operation
<CJ36DB>
○ Do not operate the tool while the switch is held.
○ The tool does not stop even if the other switch is
operated while this switch is held.
Safeguard Function
Overload Protection
Temperature Protection
18
19
20
21
22-a
22-b
23
24
― 289
to suit the operating load and
-1
Dial Blade operating speed
1 – 5 800 – 3500 min
-1
No load: 1400 min
A
With load: 3500 min
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
*4 How to use the LED light
7
<CJ36DA>
7
NOTE
To prevent the battery power consumption, turn off the
8
LED light frequently. The light goes out automatically
10 seconds after the switch is released.
8
<CJ36DB>
Pressing the lighting mode switch on the switch panel
9
switches between SW interlocked mode and Always-OFF
mode.
9
To prevent the battery power consumption, turn off the LED
9 light frequently.
9
SW interlocked mode
Light only SW-ON
(Automatically goes
State
out approximately
10 seconds after SW-
OFF)
LED LIGHT WARNING SIGNALS
(Fig. 25)
This product features functions that are designed to protect
the tool itself as well as the battery. When any of the
safeguard functions are triggered, any of the LED light will
blink as described in Table 4.
In this case, follow the instructions described under
corrective action.
-1
-1
Table 4
Remove the cause of the overloading.
Allow the tool and battery to thoroughly cool.
17
English
Table 3
Always-OFF mode
Always OFF
Fig. 25
Corrective Action