Anti-Blocking Switch (Abs); Trimming Function; Cleaning And Care - UNITED OFFICE A3 ULG 300 A1 Instrucciones De Uso

If you do not want to start another lamination
process, turn the foil thickness switch
(OFF) and withdraw the plug from the mains
power socket.

11. Anti-Blocking Switch (ABS)

At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
Turn the anti-blocking switch (ABS)
position ABS.
• The laminate pouch is not pulled any further in.
Remove the laminate pouch.
Turn the anti-blocking switch (ABS)
the desired foil thickness.
Re-start the lamination process.

12. Trimming function

Should you wish to use the trimming function on the
q
pouch guide , dismantle the pouch guide
If necessary, fold the documents supports
down.
Adjust the cutter attachment
a straight face with the foil guide rails
Slide the cutting head
e
cutting head can be slid to both ends of the
cutting rail w ).
Flap the cutting rail
grip and position the document on the pouch
q
guide . Restrain the document by sliding the
pouch format locks
both sides of the document.
Use the markings on the measurement table to
align the document precisely.
Flap the cutting rail
engages.
o
to ABS
o to the
o
back to
q
d
so that it forms
q
e to the end stop (the
w upwards with the rounded
r together until they touch
w
downwards so that it
Hold the paper in a secure position with your
left hand.
To trim, press the cutting head
the right hand and then slide it with one pull or
push over the document.

13. Cleaning and care

Potentially fatal electrical shock:
• Never open the appliance housing. There
are no user-serviceable elements inside.
• Never submerse the appliance into water
or other liquids!
Cleaning the housing:
Clean the surface of the housing with a
slightly moistened cleaning cloth.
First remove the plug.
Allow the appliance to cool down completely.
Ensure that no moisture can permeate into the
appliance.
Cleaning the interior of the appliance:
.
With every lamination, contaminants are deposited on
the rollers inside the laminator. Over time, this reduces
s
the performance of the laminator. You should therefo-
re clean the rollers inside the laminator after use.
.
Prepare the appliance as described in Chapter
8 "Preparing for hot lamination", up to the point
where the green indicator lamp "Ready"
y
glows.
Then run a sheet of DIN A3 paper, folded in
the middle (maximum thickness 1.0 mm) ...
• without a laminating pouch and
• with the fold first
... slowly into the slot for manual pouch input
Release the sheet as soon as you notice it
being pulled in automatically.
- 37 -
e
down with
t
.