Screw Connections; Moving Parts; Brushes; Entire Machine - Kerbl HappyCow Uno 18680 Instrucciones De Uso

causing loss of oil, bearing damage and possibly even damage to the gears. The oil level must also be checked on a
weekly basis. The gears have already been filled at the factory with synthetic PG 320 gear oil. Top up any lost oil
using only this type of oil. Gear oil must be changed every 10,000 hours. This is an estimate of approx. 40
hours of operation per cow per year.

5.4. Screw connections

Check all screw connections weekly to ensure they are tight, especially the attachment of the machine to the wall
and to the base plate. Tighten any screw connections where necessary.

5.5. Moving parts

Lubricate the bearings and bushings monthly. These parts must be inspected regularly and replaced if they are
wearing too much. When replacing gear parts, always use a hoist (front loader, pulley) to guard against falling
or sagging!! Risk of injury!!

5.6. Brushes

The brushes must be replaced once they have worn down and are demonstrating only inadequate cleaning
performance on the animals.
Changing the brushes
1. Unfasten the screw on the brush element and remove the clamping plate.
2. Remove the brush and replace with a new one.
3. Assemble the parts in reverse order. Secure the screw with the thread locker.
Brush cleaning
he brush element should be cleaned every 6 weeks with a suitable disinfectant.
(For example INTERKOKASK Spray #299698 from Albert KERBL GmbH)

5.7. Entire machine

The entire machine must be cleaned on a regular basis.
The gears, motor and electrical components must not be cleaned with high-pressure cleaners.
Only clean the control box with a damp sponge / cloth!

Environmental note

Please observe local waste disposal regulations! Consult your local authority if you have any questions
concerning disposal options and quantities. Note the information in the product data sheet and/or the
data printed on each label.
45