Hitachi N 14DSL Instrucciones De Manejo página 9

5) Battery tool use and care
a) Recharge only with the charger specified by the
manufacturer.
A charger that is suitable for one type of battery
pack may create a risk of fire when used with
another battery pack.
b) Use power tools only with specifically designated
battery packs.
Use of any other battery packs may create a risk
of injury and fire.
c) When battery pack is not in use, keep it away
from other metal objects like paper clips, coins,
keys, nails, screws, or other small metal objects
that can make a connection from one terminal
to another.
Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause
irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool
is maintained.
PRECAUTION
Keep children and infirm persons away.
When not in use, tools should be stored out of reach of
children and infirm persons.
PRECAUTIONS ON USING STAPLER
1. Safe operation through correct usage.
This tool was designed for driving staples into
wood and similar materials. Use it for its intended
purpose only.
2. Be careful of ignition and explosions.
Since sparks may fly during stapling, it is
dangerous to use this tool near lacquer, paint,
benzine, thinner, gasoline, gas, adhesives and
similar inflammable substances as they may ignite
or explode. Under no circumstances should this
tool therefore be used in the vicinity of such
inflammable material.
3. Always wear eye protection (protective goggles).
When operating the power tool, always wear eye
protection, and ensure that surrounding people
wear eye protection too.
The possibility of fragments of staples or staples
that were not properly hit entering the eye is a
threat to sight. Eye protection can be bought at
any hardware store. Always wear eye protection
while operating this tool. Use either eye protection
or a wide vision mask over prescription glasses.
Employers should always enforce the use of eye
protection equipment.
4. Protect your ears and head.
When engaged in stapling work please wear ear
mufflers and head protection. Also, depending on
condition, ensure that surrounding people also
wear ear mufflers and head protection.
5. Pay attention to those working close to you.
It would be very dangerous if staples that were
not properly driven in should hit other people.
Therefore, always pay attention to the safety of
the people around you when using this tool.
Always make sure that nobody's body, hands or
feet are close to the staple outlet.
6. Never point the staple outlet towards people.
Always assume the tool contains fasteners.
If the staple outlet is pointed towards people,
serious accidents may be caused if you mistakenly
discharge the tool. When connecting and check
disconnecting the hose, during staple loading or
similar operations, be sure the staple outlet is not
pointed towards anyone (including yourself). Even
when no staples are loaded at all, it is dangerous
to discharge the tool while pointing it at someone,
so never attempt to do so. No horseplay. Respect
the tool as a working implement.
7. Before using the power tool, check the push
lever.
Before using the power tool, make sure to check
that the push lever operate properly. Without staples
loaded into the power tool, connect the battery and
check the following. If the sound of operations
occurs this indicates a fault, so in such a case do
not use the power tool until it has been inspected
and repaired.
If merely pulling the trigger causes operating
sound of drive bit movement occur, the power
tool is faulty.
If merely pushing the push lever against the
material to be stapled causes the sound of drive
bit movement to occur, the power tool is faulty.
Furthermore, with regard to the push lever, please
note that it must never be modified or removed.
8. Use specified staples only.
Never use staples other than those specified and
described in these instructions.
9. Do not carelessly place your finger on the trigger.
Do not place your finger on the trigger except
when actually stapling. If you carry this tool or
hand it to someone while having your finger on
the trigger, you may inadvertently discharge a
staple and thus cause an accident.
10. Completely Close the blade guide and do not
open it during operation.
If stapling is attempted when the blade guide is
open, staples will not be driven into the timber,
and there is a risk of dangerous discharge.
11. Press the staple outlet firmly against the material
to be stapled.
When driving in staples, press the staple outlet
firmly against the material to be stapled. If the outlet
is not applied properly, the staples may rebound.
12. Keep hands and feet away from the firing head
when using.
It is very dangerous for a staple to hit the hands
or feet by mistake.
13. Beware of the tool's kickback.
Do not approach the top of the tool with your
head etc. during operation. This is dangerous
because the tool may recoil violently if the staple
currently being driven in comes into contact with
a previous staple or a knot in the wood.
English
8