Maintenance And Inspection - Hitachi N 14DSL Instrucciones De Manejo

Make sure the trigger has been locked and the battery
removed when using the hook.
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Removing the hook.
Remove the screws fixing the hook with Philips screw
driver. (Fig. 11)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool
and tighten the screws to fix the hook firmly. (Fig.
12)

MAINTENANCE AND INSPECTION

WARNING
Make sure the trigger has been locked and the battery
removed before carrying out inspections and
maintenance. Also make sure that the recharger has
been unplugged.
1. Removing Staple Jams (Fig. 13)
(1) Remove the battery from the power tool
(2) Press the stop lever, slide open the magazine and
remove all staples.
(3) Remove adhesive of staples, fragments and splinters
that have collected in the blade guide with a flathead
screwdriver or similar implement.
(4) Check to ascertain that the push lever works smoothly.
NOTE
After removing staple jams, reload the staples and
fire a test staple.
2. Magazine Inspections
The inside of the magazine needs to be cleaned from
time to time. Slide the magazine open and remove
adhesive of staples, fragments and splinters that have
collected.
NOTE
Dirt inside the magazine may result in the operations
of the staple feeder becoming sluggish, which may
cause blank firing.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so may result in serious hazard.
4. Cleaning of the outside
When the power tool is stained, wipe with a soft dry
cloth or a cloth moistened with soapy water. Do not
use chloric solvents, gasoline or paint thinner, as
they melt plastics.
5. Storage
Store the power tool in a place in which the
temperature is less than 40°C, and out of reach of
children.
NOTE:
Make sure that the battery is fully charged when
stored for a long period (3 months or more). The
battery with smaller capacity may not be able to be
charged when used, if stored for a long period.
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
Repair, modification and inspection of Hitachi Power
Tools must be carried out by a Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
Important notice on the batteries for the Hitachi
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when
used with batteries other than these designated
by us, or when the battery is disassembled and
modified (such as disassembly and replacement
of cells or other internal parts).
GUARANTEE
We guarantee Hitachi Power Tools in accordance with
statutory/country specific regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling
instruction, to a Hitachi Authorized Service Center.
NOTE:
Due to HITACHI's continuing program of reserch and
development, the specifications herein are subject to
change without prior notice..
English
14