Power Supply; Application; General - Beurer MP 42 Instrucciones Para El Uso

The integrated LED light additionally creates ideal light conditions during

application.

2.2 Power supply

To ensure adequate power at all times for good and powerful treatment of
the feet and nails, this instrument is provided with a permanently attached
power unit.
3. Application

3.1 General

– This instrument is intended only for the treatment of hands (manicure)
and feet (pedicure).
– Make sure that the device is switched off beforehand.
– Select an attachment and push it onto the instrument spindle using a
slight pressure. To remove: pull the attachment and instrument apart in
the axial direction (straight).
– Switch the device on by moving the slide switch down (anticlockwise,
LED red) or up (clockwise, LED green).
– The LED lights up blue. The two buttons marked with plus (+) and minus
(-) allow you to select the speed of rotation. Start every application at low
speed and increase it only as required.
– Blue LEDs light up on the surface of the device depending on the se-
lected speed.
– You can select one of two speed settings (Hi and Lo). Press the corre-
sponding button on the device
– Do not exert heavy pressure and always guide the attachments carefully
over the surface to be treated.
– Move the instrument under light pressure in circular movements slowly
over the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is
softened or moist. For this reason, do not carry out any pretreatment in a
bath.
– Do not remove all the callus skin in order to retain the natural protection
of the skin.
– Always ensure that the spindle can rotate freely. It must never be perma-
nently jammed, otherwise the instrument will become too hot and suffer
damage.
– After every use, apply moisturizing cream to the parts treated.
16