Position Bluetooth Receiver - Schluter Liprotec LT EBR 1 Manual De Uso

EN
Mounting
Tighten the two cross-recess screws by hand.

You can now remove the sticker and store the

remote control in the wall bracket.

5.2 Position Bluetooth receiver

You can position the Bluetooth receiver in an installation box
or behind the panelling between the power pack and LED
strips.
To obtain good reception and the greatest possible operating
safety, observe the following points for positioning the
Bluetooth receiver:
Make sure that the maximum permissible lengths of the

connection cable are not exceeded:
– The length of the connection cable to the power
pack may not exceed 2 m. Connect the Bluetooth
receiver directly to the power pack if possible.
– The length of the connection cable to the installation
box, into which the connections of several LED
strips are combined, may not exceed 10 m.
– The length of the connection cable to a directly
connected LED strips may not exceed 3 m.
Position the Bluetooth receiver at least 50 cm above the

floor of the room.
Ensure that the radio reception at the selected

installation location is not impeded by metal objects or
the mains cable.
54 Bluetooth receiver directions for use