Display Problems; Printer Problems; Status Led; Solutions - Midtronics MicroXL Serie Manual De Instrucciones

GB

DISPLAY PROBLEMS

If the display does not turn on:
• Check the connection to the vehicle battery.
• The vehicle battery may be too low (below 1 volt) to power the
analyzer. Fully charge the battery and retest.
• The analyzer's 9-volt battery may need to be replaced. Follow the
directions in "Replacing the Analyzer Battery" and replace the 9-volt
battery (alkaline recommended).
• If the analyzer does not power on when you press and hold the MENU
button, replace the 9-volt battery.
• If troubleshooting does not solve the problem, call 800-776-1995 to
obtain service. See "Patents, Limited Warranty, Service" for more
information.

PRINTER PROBLEMS

Status LED

When a printer fault occurs, the STATUS LED will flash. You can identify
the fault by the number of sequential flashes:
Sequence
* * *
** ** **
*** *** ***

Solutions

• If the IR transmitter and receiver are not aligned, all the data may not
print. The infrared ports on the top of the MicroXL and on the bottom
of the printer (below the MODE button) should be pointed directly at
each other. The maximum distance for reliable transmission between
the ports is 18 inches (45 cm).
E
NGLISH
Condition
Paper out
Thermal head too hot
Battery low
19
• •
Solution
Fit new paper
Allow head to cool
Recharge printer
battery for 16 hours