Measurements; Simple Distance Measurement - Multimetrix DM 100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
Lighting of the
display unit
Programming
the units

4. Measurements

Simple
distance
measurement
Continuous
measurement
(Tracking) &
Measurements
of Max and
Min
22
Press the Backlight/Units key to switch the
backlighting of the LCD display unit on or off.
A long press on this key changes the
measurement unit (m, ft., in, ft+in).
Press once to activate the laser.
Press again to trigger the measurement.
The value measured is displayed immediately.
The continuous (tracking) measurement mode is used to
locate a specified distance, for example one marked on a
drawing. In the continuous measurement mode, the
distance meter can be moved with respect to the target;
the reading is refreshed approximately twice a second and
displayed on the third line. The minimum and maximum
values are automatically indicated on the first and second
lines.
For example, the user can move away from a wall to the
desired distance, since the current distance can be read
continuously. For the continuous mode, press
the continuous measurement indicator appears on the
display unit. Press the MEAS key or the erase key to stop
the function. The function stops automatically after 100
successive measurements.
Laser Distance Meter DM 100
until

Publicidad

Tabla de contenido
loading

Tabla de contenido