Bosch WEU PLR 30 C Manual Original página 30

OBJ_BUCH-2312-004.book Page 30 Tuesday, November 8, 2016 4:12 PM
30 | English
For data transmission via Bluetooth®, time delays between mobile terminal/device
and measuring tool may occur. This can be possible due to the distance between both
devices or the object being measured.
Activating the ® Interface for Data Transmission to a Mobile Terminal/
Device
To activate the Bluetooth® interface, press the measuring tool's Bluetooth® button 3.
Make sure that the Bluetooth® interface on your mobile terminal/device is activated.
The special Bosch app "PLR measure&go" is available to extend the range of functions
of the mobile terminal/device and to make data easier to process. It can be download-
ed in the respective stores, depending on the device:
The connection between mobile terminal/device and measuring tool is established af-
ter the Bosch application has started. If multiple active measuring tools are found, se-
lect the appropriate measuring tool.
The connection status and the active connection are indicated on the display 5 (a).
If no connection can be established within 3 minutes of pressing the Bluetooth® but-
ton 3, Bluetooth® will automatically switch off to save the batteries/rechargeable bat-
teries.
Deactivating the ® Interface
To deactivate the Bluetooth® interface, press the Bluetooth® button 3 or switch the
measuring tool off.
1 609 92A 27L | (8.11.16) Bosch Power Tools