Presetting Stations - Aiwa CSD-MD5 Manual De Instrucciones

PRESETTING STATIONS

The unit can store a total of 20 preset stations. When a
station is stored, not only a preset number is assigned to the
station, but a station name can be registered.
Use the preset number to tune in a preset station directly.
1
5
5
1
Press RADIO/BAND to select a band.
2
Turn JOG DIAL to select a station.
3
Press ENTER.
MANUAL SET is displayed for 10 seconds.
4
Within 10 seconds, press ENTER to store the
station.
The unit turns into character entry mode.
5
Enter the station name.
(1) Press CHARACTER repeatedly to select the kind of
character (capital letters, small letters or number/
symbols).
→ Capital letters → Small letters —
Numbers/symbols ←
(2) Turn JOG DIAL to select a desired character.
(3) Press CURSOR b after you have selected a
character.
The selected character stops flashing and the flashing
moves to the right.
Repeat steps (1) to (3) to enter all the characters (up to
10 characters).
After entering the name press ENTER.
• If the unit is left for one minute, the station name is not
registered.
• Refer also to page 18 on character entry in detail.
6
Repeat steps 1 to 5 to store stations.
k, i
2, 5
3, 4, 5
0-15, +10
PRESET NUMBER TUNING
1
Press RADIO/BAND to select a band.
2
Press k, i repeatedly.
Each time it is pressed, the next ascending number is
selected.
Preset number
To select a preset number directly with the remote
control
Press RADIO FM/AM to select a band. Then, press the
numbered buttons 0-15 and +10 to select a preset number.
Example:
To select preset number 20, press +10 twice and 0.
To select preset number 16, press +10 and 6.
En
E
F
11
ENGLISH