How To Perform Tests - TENTECH MD1035x Manual De Uso

6. How to perform tests

Press  key. The high voltage LED turns on immediately,
indicating that the equipment internal generator is applying
voltage to the element that is being tested. Then, the display will
show the test number, the selected voltage value and it will start
the elapsed time count.
For a few seconds, the auto-range system will search for the most
convenient range for the value being measured. Meanwhile, the display
will show the message:
If the measured value is within the device scope, the test number
indication will provide place for the resistance value indication and its
corresponding unit, and it will start the analog bargraph indication.
If the measured value exceeds 1 TΩ @ 1 kV, the following message will
be read:
19