Hold; Internal Memory; Auto Power-Off - TENTECH MD1035x Manual De Uso

7.3. Hold

The  key allows to hold the last performed reading on the display, at
the moment this key was pressed, without interrupting the test. When this
key is pressed again, the equipment updates the resistance and time
values. The  key LED and the letter H on the display indicates that the
function was activated.

7.4. Internal memory

This equipment has an internal memory for up to 4000 measured values.
This memory is administrated by the instrument and works in a cyclic
way, this means, when the memory is full, the oldest values in the
memory will be replaced by the newest ones. To avoid lost of data,
always download the internal memory after finish the measurements.

7.5. Auto power-off

The Auto-power-off function turns off the equipment consumption
(independently of the timer function) in two situations:
During the measurement - After 35 minutes of measuring without
•
checking the battery status.
Idle equipment - After 10 minutes of inactivity.
•
22