Storage And Cleaning - Velleman CAMSET24 Manual Del Usuario

Play Video
Select the desired video and press the play/pause button [J3]. This function will not work if no
USB device is available.
Record Video
After showing the message 'Line initializing', the camera image is shown. Press the record
button [J2] to start recording. Press the record button [J2] again to stop recording but remain
in camera view mode. Press the stop button [J9] to stop recording en return to the menu.
This function will not work if no USB device is available.
System Setting
Playmode setting: set the video playback options
*Repeat/Shuffle
Clock setting: set date and time
*TimeFormat
Year
Month
Day
Hour
Minute
Second
Display setting: set on-screen display settings
*Language
Subtitling Mode
System: shows software version, product version, free space and used space (when USB
connected)
Record setup
Source
Resolution
Bitrate
Sampling
Switchon autorun
Master reset: press OK again to perform a master reset
Firmware update: locate the directory where new firmware is stored
Record Section List: not applicable for this system
Browse File
Shows all files on the current USB medium.
Remove USB device (only when USB device is connected)
Always use this option before pulling the USB device from the USB port
• After setting up the system or to quit the setup, press the power button [J1]. Press it again to
start viewing images from the camera again.

9. Storage and cleaning

• Always return the equipment back to its protective case when not in use.
• Use a clean, soft and dry cloth to wipe the cable and camera clean after each use. Do not close
the case with wet equipment inside as this will increase the risk of mould.
• Clean the rest of the equipment with a clean dry cloth. Never use solvents or abrasive solutions.
10. Fuse
• If the status LEDs on the battery pack don't light up after switching on the battery pack [E],
check the fuse [E5].
• Turn the fuse cap [E5] counter clockwise to remove it from the battery pack.
• Only replace the fuse with a new one with the same specifications as the original one (F2A250V).
05/05/2010
CAMSET24
Select: Normal – Repeat – Shuffle - Reverse
Select: 24Hour - 12Hour
Set year
Set month
Set day
Set hour
Set minutes
Set seconds
Select: English - Chinese
Select: Open - Close
Select: PAL - NTSC
Select: 640*480 - 720*480 - 320*240 - 480*360
Select: 1000 - 1200 - 1500 - 1800 - 2100 - 2500KB/s
Select: 32KHz – 24KHz
Select: Close - Open
6
© 2008 Velleman Components nv