Troubleshooting - Omron Comp AIR NE-C28-E Manual De Instrucciones

NE-C28.book Page 21 Monday, October 23, 2006 3:40 PM

8. Troubleshooting

Check the following if your unit should fail during operation. You can also refer to
the pages of this manual for complete instructions.
Symptom
Nothing happens when the
power switch is pressed.
No nebulisation or low
nebulisation rate, when the
power is on.
The device is abnormally
loud.
The device is very hot.
Notes:
• If the suggested remedy does not solve the problem, do not try to repair the
device - no parts of the unit are user serviceable.
Return the unit to an authorized OMRON retail outlet or distributor.
• The device should be serviced once a year by an approved OMRON service
centre.
Cause
Is the power plug plugged
into an electrical outlet?
Is there medication in the
medication tank?
Is there too much/little
medication in the medication
tank?
Is the vaporiser head
missing and not assembled
correctly?
Is the nebuliser kit
assembled correctly?
Is the nozzle blocked?
Is the nebuliser kit tilted at a
sharp angle?
Is the air tube connected
correctly?
Is the air tube folded or
damaged?
Is the air tube blocked?
Is the air filter dirty?
Is the air filter cover attached
correctly?
Are the ventilation slots
blocked?
Remedy
Check that the plug is
inserted in an electrical
outlet. Unplug then reinsert
the plug if necessary.
Fill the medication tank.
Add the correct amount of
medication to the medication
tank.
Attach the vaporiser head
correctly.
Assemble the nebuliser kit
correctly.
Make sure that the nozzle is
free of blockages.
Make sure that the nebuliser
kit is not tilted at an angle of
more than 45 degrees.
Make sure that the air tube is
correctly connected to the
compressor and nebuliser.
Make sure that the air tube
does not contain kinks.
Make sure that the air tube is
free of blockages.
Replace the air filter with a
new one.
Attach the air filter cover
correctly.
Do not block the ventilation
slots.
EN
21