Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ADJUSTING AIR PRESSURE
Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar 5 –
2
8.5 kgf/cm
) according to the length of nails and the hardness of workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a
higher than required air pressure unnecessarily over stresses the Nailer.
LOADING NAILS
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back and hang it over the roll pin.
(2) 1 Insert nail strips one by one from above the magazine.
2 Slide nails forward in the magazine.
16
WARNING
● Do not exceed 120 psi
(8.3 bar 8.5 kgf/cm
WARNING
Nail Feeder
Roll pin
1
2
Nail strips
Magazine
2
).
Publicidad
Tabla de contenido
