Parts Identification; Power Switch; Liquid-Crystal Display - Sony UHF Serie Manual De Instrucciones

Parts Identification

1

POWER switch

Antenna
2
Liquid-crystal
B A T T
display
C H
S E T
3
SET button
+
–
4
+/– buttons
Location of parts
1 POWER switch
Turns the power of the transmitter ON or OFF.
When you set this switch to ON without holding any other
button, the transmitter is set to normal Transmit mode and
transmits the signal of the selected channel.
When you set this switch to ON while holding the SET
button down, Setting mode is initiated. No signal is
5
Audio input
transmitted in Setting mode.
connector
For setting mode, see "Settings" on page 12.
Note
6
INPUT level
Be sure to connect a microphone or guitar cable before
switch
turning the power ON.
7
PHASE switch

2 Liquid-crystal display

8
Belt clip
Battery
compartment
(See page 9.)
a AF (audio input) indication
Lights when an audio signal over the reference level is being
supplied.
a b c
AF RF BATT
CH
d
7