Fisher-Price POWER WHEELS Monster Traction R3142 Manual Del Usuario página 32

PROBLEM
Vehicle runs in low speed, but
does not run in high speed.
Please note: The vehicle is
designed to operate in low
speed only in reverse.
When the foot pedal is pressed
one rear wheel spins
Sometimes the vehicle doesn't run,
but other times it does
When the foot pedal is pressed,
the vehicle won't run without
a push
Battery's thermal fuse constantly
"trips", but the vehicle is not
overloaded nor the driving
conditions too severe
Loud clacking or grinding noise
from a motor-gearbox
Charger gets warm during use
Battery makes a sizzling or
gurgling noise when charging
POSSIBLE CAUSE
High speed hook-up is disconnected
Operation of vehicle in low speed
Loose wire or connector
Motor or electrical switch damage
Loose wire or connector
"Dead Spot" on motor
Damaged battery
Child is switching between FORWARD and
REVERSE without stopping
Broken gears
It is normal for some chargers to get warm
during use and is not reason for concern
It is normal for some batteries to make noise
and swell slightly while charging and is not
reason for concern
The vehicle was pre-set to run only in low speed. To allow the vehicle to
run in low and high speed, you must connect the High Speed connectors.
Follow the instructions on page 28.
Note: The high speed connectors must be joined to use the high speed grip.
It is possible that only one rear wheel may spin when both rear wheels
are raised off the ground and the vehicle is in low speed. This does not
necessarily indicate a problem. Check for proper operation of the drive
system by raising the rear wheels off the ground and pressing the foot
pedal. If only one rear wheel spins, carefully press your hand on the
spinning wheel to slow it down. The other rear wheel should begin to spin.
If the other rear wheel does not begin to spin, there may be a problem
with the vehicle. Contact Consumer Relations.
Check all wires and connectors. Make sure the motor harness connector
is plugged into the battery, and that there are no loose wires around
the motors.
The electrical switches can become corroded due to exposure to water or
moisture, or can jam due to loose dirt, sand or gravel. Contact
Consumer Relations.
Check all wires and connectors. Make sure the motor harness connector
is plugged into the battery, and that there are no loose wires around
the motors.
Contact Consumer Relations.
Contact Consumer Relations.
Teach your child to stop the vehicle before switching direction.
Contact Consumer Relations.
No action required.
If your charger does not get warm during use, it does not mean that it is
not working properly.
No action required.
If your battery does not make noise or swell slightly during charging,
it does not mean that it is not accepting the charge.
32
SOLUTION
R3142pr-0720