Hilti SCM 18-A Manual De Instrucciones página 6

2.2 Switch
On / off switch with switch-on interlock
2.3 Grips
Grip and auxiliary grip
2.4 Safety precautions
Blade guard and pivoting guard
2.5 Lubrication
Grease lubrication
2.6 Protection against overload and overheating
The power tool is equipped with an electronic protection system to prevent overloading and overheating. The power
tool switches itself off automatically in the event of overloading and overheating. After releasing the on / off switch,
the power tool may not restart immediately when the switch is pressed again (while the power tool is cooling down).
2.7 Lithium‑ion battery charge status
When a lithium-ion battery is used, the charge status can be indicated by gently pressing one of the battery release
buttons (press until resistance is felt - do not release the battery). The display on the rear of the battery provides the
following information:
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
2.8 Items supplied as standard
1 Power tool
1 Saw blade
1 Hexagon socket wrench
1 Operating instructions
1 Hilti toolbox (optional)
1 Cardboard box (optional)
1 Rip fence / parallel guide (optional)
2.9 Additional items required for operating the tool
B18/2.6 Li‑ion or B18/3.3 Li‑ion battery and C4/36, C4/36‑ACS, C4/36‑90 or C4/36‑350 charger.
NOTE
Depending on the version, these items may be supplied with the power tool.
LEDs blink
-
-
-
-
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
en
3