External Fiber-Optic Illumination; Placing Reversible Eyepiece Cup Onto The Eyepiece; Insert The Eyepiece Plate Into The Eyepiece - Zeiss Stemi 305 Instrucciones De Manejo

Stereo microscope
Stemi 305
3.3.1.3

External fiber-optic illumination

•
Switch on external fiber-optic illumination
(Fig. 15/1), adjust illumination intensity and set
illumination by bending the two goose necks
(Fig. 15/2) so that the specimen is optimally lit.
To this effect, refer also to the
separate operating
regarding the cold light source.
3.3.1.4

Placing reversible eyepiece cup onto the eyepiece

The eyepieces feature rubber protection rings for spectacles to avoid the spectacles being scratched.
These rings may be replaced at choice by reversible eye cups (Fig. 16/1).
•
To this effect remove the protection rings for spectacles (Fig. 16/2) from the eyepieces and position
the eye cups (Fig. 16/1).
3.3.1.5 Insert the eyepiece plate into the
eyepiece
The adjustable eyepieces are intended for use with
eyepiece plates.
•
Unscrew stop (Fig. 16/6) out of the eyepiece
(Fig. 16/3).
•
Pull locking ring (Fig. 16/4) out.
•
Insert eyepiece plate (Fig. 16/5).
•
Insert locking ring and re-fasten stop.
If eyepiece plates are inserted by the
customer, it must be ensured that the
writing is mirror-inverted before inser-
tion into the eyepiece, and true to side
after insertion.
Fine cotton gloves should be worn to insert or replace eyepiece plates.
04/2015
INSTALLATION
Mounting optional components
instructions
Fig. 15
Fig. 16
435063-7044-010
Mounting external fiber-optic
illumination
Inserting the eyepiece plate
ZEISS
21