Fig. 9 Mounting Ring Illuminator; Fig. 10 Mounting External Fiber-Optic Illumination - Zeiss Stemi 508 Instrucciones De Manejo

ZEISS
Fig. 9 Mounting ring illuminator
Fig. 10 Mounting external fiber-optic
illumination
22
INSTALLATION
Mounting optional components
3.3.1.2
•
Push holding ring A53 (Fig. 9/2) from the
underside onto the dust protection glass
(Fig. 9/1) of the Stemi 508 and secure it by
tightening the two retainer screws (hexagon
socket, SW 3).
•
Insert the connection cable (Fig. 9/5) of the ring
illuminator (Fig. 9/3) into the lower socket
(Fig. 9/6) of the Stemi mount and into the
socket of the ring illuminator.
•
Push ring illuminator onto the retainer ring A53
(Fig. 9/2) from below and secure using the
knurled screw (Fig. 9/4).
If front optics 5 Apo is used on the microscope
instead of the dust protective glass, locking ring
A53 will not be required for the assembly of the
ring illuminator!
•
Instead, insert the slotted adapter ring (supplied
with the front optics) into the ring illuminator.
•
Then push the ring illuminator including the
adapter up on the front optics and fix it with
the clamping screw (see Fig. 9).
3.3.1.3
•
Switch on external fiber-optic illumination
(Fig. 10/1), adjust illumination intensity and set
illumination by bending the two goose necks
(Fig. 10/2) so that the specimen is optimally lit.
435064-7144-008
Stereo microscope
Mounting ring illuminator K LED
(segmentable)
External fiber-optic illumination
To this effect, refer also to the
separate operating
regarding the cold light source.
Stemi 508
instructions
09/2017