Changing Operating Mode - Makita XCV19 Manual De Instrucciones

Limpiador vertical inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Switch action
► 1. ON / mode change button 2. OFF button
Turning on / off the appliance
To start the appliance, simply push the ON / mode
change button. To switch off, push the OFF button.
CAUTION:
Always put the head of the appli-
ance on the floor when turning on the appliance.
Otherwise an accident due to entanglement may
occur and cause a personal injury.

Changing operating mode

You can change the operating mode in three steps:
"lower noise level (1)", "normal (2)", and "high (3)".
If you want to change operating mode, press the ON
/ mode change button when the appliance is running.
The operating mode switches in order "lower noise level
(1)" , "normal (2)" , and "high (3)".
The appliance will start in the same mode as the previ-
ous setting.
Lighting up the LED lamp
CAUTION:
Do not look in the light or see the
source of light directly.
The appliance is equipped with the LED lamps.
See the paragraph of the battery check / LED lamp
button for operation.
1
► 1. LED lamp
Foot lever
CAUTION:
upright position when you let go of the handle.
1
Otherwise the appliance may accidentally fall and
cause injury.
CAUTION:
2
gers between the main body and the head of the
appliance.
To unlock the upright position of the appliance, step on
the foot lever and pull the handle backward.
The range of motion is 90 degrees from the upright position.
► 1. Foot lever
To lock the appliance in upright position, raise up the han-
dle forward until the foot lever locks the position with click.
NOTE: While the appliance is in the upright position,
the brushroll stops rotating.
Adjusting the height of brushroll
CAUTION:
ing lever comes into the position properly before
operation.
The height of brushroll can be adjusted in 4 steps.
Turn the adjusting lever to your desired height.
When the adjusting lever points the A mark, the
brushroll is located at the lowest point above the floor
and is suitable for cleaning hard floors and short-haired
carpets. When the adjusting lever points the B mark, the
brushroll is located at the highest point above the floor
and is suitable for cleaning long-haired carpets.
11 ENGLISH
Always lock the appliance in
Be careful not to pinch your fin-
1
Always make sure that the adjust-

Publicidad

Tabla de contenido
loading

Tabla de contenido