Hazardous Dust; Spare Parts And Accessories; In Explosive Or Inflammable Atmosphere; Control / Operation - Makita VC4210L Manual Original

by an authorized Makita dis-
tributor or similar qualified
person in order to avoid a
hazard.
4. In no circumstances should
the power supply cord be
wrapped around fingers or
any part of the operators
person.
2.2

Hazardous dust

WARNING
Hazardous materials.
Vacuuming up hazardous
materials can lead to serious
or even fatal injuries.
1. The following materials
must not be picked up by
the machine:
– hot materials (burning cig-
arettes, hot ash, etc.)
– flammable, explosive,
aggressive liquids (e.g.
petrol, solvents, acids, al-
kalis, etc.)
– flammable, explosive dust
(e.g. magnesium or alu-
minium dust, etc.)
2.3

Spare parts and accessories

CAUTION
Spare parts and accessories.
The use of non-genuine spare parts, brushes
and accessories can impair the safety and or func-
tion of the appliance.
*) Optional accessories / Option depending on model
Original instruction
1. Only use original spare parts and accessories
from Makita. Spare parts that can affect health
and safety of the operator and or function of the
appliance, are specified below:
Description
Flat filter PTFE, 1 pcs.
Fleece filter bag, 5 pcs.
Disposal bag, 5 pcs.
Motor cooling air filter PET, 1 pcs.
2.4

In explosive or inflammable atmosphere

CAUTION
This machine is not suitable for use in explo-
sive or inflammable atmospheres or where
such atmospheres are likely to be produced by the
presence of volatile liquid or inflammable gas or va-
pour.
3

Control / Operation

CAUTION
Damage due to unsuitable mains voltage.
The appliance can be damaged as a result of
being connected to an unsuitable mains voltage.
1. Ensure that the voltage shown on the rating plate
corresponds to the voltage of the local mains
power supply.
3.1

Starting and operating of the machine

1. Check that the electrical switch is switched off
(in position 0).
2. Check that suitable filters are installed in the
machine.
3. Connect the suction hose into the suction inlet at
the machine by pushing the hose forward until it
fits firmly in place at the inlet.
4. Connect the tubes with the hose handle, twist
the tubes in order to ensure that they are prop-
erly fitted.
5. Attach suitable nozzle to the tube. Choose noz-
zle depending on what type of material that is to
be picked-up.
6. If used for dust extraction in connection with
dust producing tool then connect end of suction
hose with appropriate adapter.
7. Connect the plug into a proper electrical outlet.
8. Put the electrical switch into position I in order to
start the motor.
D
Makita VC4210L
GB
F
NL
Order No.
I
W107418351
N
W107418353
W107418355
S
W107418352
DK
SF
E
P
GR
TR
SLO
HR
SK
CZ
PL
H
RO
BG
RUS
EST
LV
LT
AL
MK
SR
UK
15