Installing The Filter Bag - Makita XCV19 Manual De Instrucciones

To install the battery cartridge, release the lock first, and
then open the battery cover. After that, insert the battery
cartridge.
1
2
► 1. Lock 2. Battery cover
Align the tongue on the battery cartridge with the groove
in the housing and slip it into place. Insert it all the way
until it locks in place with a little click. Then lock the
battery cover.
► 1. Battery cartridge 2. Button
To remove the battery cartridge, slide it from the appli-
ance while sliding the button in front of the cartridge.
CAUTION:
Always install the battery cartridge
fully. If not, it may accidentally fall out of the appli-
ance, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The cleaner does not work with only one
battery cartridge.

Installing the filter bag

CAUTION:
Do not use a damaged filter bag.
Always use the vacuum cleaner with the filter bag
properly installed. Otherwise the vacuumed dust
or particles may be exhausted from the cleaner
and they may cause respiratory disease to the
operator.
Install the filter bag before using cleaner.
Filter bag is a throw-away type. Throw away the entire
filter bag without emptying when it has become full.
1
2
NOTICE:
When the filter bag is already full or
clogged, replace with new one. Continuous use
with the filter bag full or clogged results in reduced
suction power.
NOTICE:
To prevent dust from getting into the motor:
— Make sure that the filter bag is installed
before use.
— Do not use a broken or ripped bag.
Otherwise the motor may be broken.
NOTICE:
Do not fold the cardboard at its open-
ing when installing the filter bag.
NOTICE:
The filter bag for the cleaner is an
important component for maintaining the appli-
ance performance. Using non-genuine filter bag
may cause smoke or ignition.
NOTE: When the filter bag is not installed in the appli-
ance, the dust box cover does not close completely.
1. Unlock the lever and open the dust box cover.
► 1. Lever 2. Dust box cover
2. Insert the filter bag into the slot on the holder so
that the side with mark
3. Hook the latch of the holder.
2
► 1. Slot 2. Filter bag 3. Holder 4. Latch
8 ENGLISH
1
2
enters first.
3
1
4