Dentsply Sirona SmartLite Pro Manual De Istrucciones página 11

Signal Condition
Battery Insertion
Start Cycle
Second power level
Stop cycle manually
End of cycle
Warnings
(i.e. no head attached)
Low battery
Empty battery
Overheating protection
3.1 Installation and charging
1. Insert battery pack into SmartLite Pro handpiece
charged however, it may be necessary to charge the battery before first use.
2. To recharge the battery:
• Connect the charging base to the Power Cord using the USB mini connector
• Make sure power socket used for power connector is accessible at all times in case of
necessary emergency disconnection.
• Insert the battery onto the charging base
orange, indicating battery is recharging and will show constant green when fully charged.
Note, the SmartLite Pro comes with two batteries. It is recommended that the battery not
being used is stored on the charging base so that it is fully charged when needed.
3.2 Operation – Curing
1. Select the appropriate LED curing tip for the material to be cured. Attach the tip to the
handpiece by firmly pressing tip into handpiece opening while slightly rotating at the same
moment.
Insufficient Curing – compromised restoration
• Always select the curing tip according to the wavelength of the initiator(s) in the
material to be cured.
• Observe recommended curing time for the chosen tip and curing application.
2. Protect LED tip from gross debris by applying an FDA-cleared, single use SmartLite Pro
barrier protection sleeve
the sleeve D4 .
Cross-contamination
• Ensure the disposable polyethylene FDA-cleared barrier protection sleeve has
been correctly applied over the entirety of the LED tip and handpiece before
beginning a procedure
• The Polyethylene barrier Sleeve does not replace cleaning and disinfection of
the dental instruments. Please clean and reprocess dental instruments after each
patient as described in Section 4, Hygiene and Maintenance
3. Attach the SmartLite Pro eye protection shields supplied with the unit in combination with
SmartLite Pro barrier protection sleeves. Hold the tip over the opening of the shield and
turn the tip against the shield by 90° into its final position
Pro eye protections shields are securely fixed to SmartLite Pro to avoid accidental aspiration
(press SmartLite Pro eye protection shield firmly into correct position). Always make sure
SmartLite Pro eye protection shields are properly mounted on SmartLite Pro without
covering the light aperture
4. Use suitable, light filtering safety glasses
Transillumination Tip
Vibration Beep Signal LED
- 1x
- 1x
- 1x
- 1x
- 1x
- 2x
- -
- - blinking fast
- 4x continuous
A&B
B2 . The battery light
D
. Make sure that the lens is not blocked by crinkles or seam of
D3 .
E3
.
Cure / PolyCure Tip
Vibration
- -
- 1x
- NA
- 1x
- 1x
- 2x
blinking -
-
4x
B3
. SmartLite Pro battery pack is pre-
5.5
E2
. Always make sure SmartLite
Beep Signal LED
1x -
1x -
NA NA
1x -
1x -
2x -
- blinking
- blinking fast
4x continuous
A2
will illuminate solid
11