Installer Manual; Device Installation; 2.1. In A Control Panel - Urmet 1083/58 Manual De Usuario

2.

DEVICE INSTALLATION

Installation of the device must be carried out by a
skilled installer.
The Call Forwarding Device can be used to
forward a voice-video call or a voice-only call to
a smartphone with the Android or iOS operating
system.
This is done by establishing an Internet connection
through an ADSL router/modem or via 3G/4G using
a Cat5 cable or via Wi-Fi.
The Urmet CallMe App must be downloaded to the
user's smartphone, connected to the Internet via a
mobile data or Wi-Fi connection, in order to be able
to receive the call.
In addition to receiving the call, the Urmet CallMe
App also ensures intercommunication with other
smartphones connected to the same account.
Moreover, the Urmet CallMe App is necessary to
be able to confi gure the device parameters.
The Call Forwarding Device only works
in combination with one or more indoor
stations available in the apartment and
is always confi gured as if it were an
indoor station with ID/code equal to 3
To ensure correct operation of the Urmet CallMe
App, some essential requirements must be
verifi ed:
1) good Wi-Fi signal quality on the device;
2) upload data band ≥ 300 kbps for the Internet
service supplied by your home provider to the
device;
3) check that your smartphone data plan does not
require VoIP data fl ow locking.
WARNING
Applications that:
— optimise the use of the battery,
— ensure energy saving for your smartphone,
— protect the device
software),
could adversely affect the operation of the
Urmet CallMe application when in the off-screen
(background) mode.
The Call Forwarding Device can be installed in one
of the following ways:
DS1083-078

INSTALLER MANUAL

(antivirus or similar

2.1. IN A CONTROL PANEL

1. Insert the spacer behind the device in its special
seat, ensuring that it is locked by the lever A.
2. Insert the retainers B of the spacer in the DIN
rail in such a way that the terminal strips of the
device are pointing downwards, then insert the
retainers C.
3. Remove the terminal strip cover.
2
1
4. Connect the assembly to the system.
5. Carry out the device confi guration by means of
jumpers and/or dip-switches.
6. Replace the terminal strip cover.
7. Power on the device.
8. Complete your parameter confi guration by
using the Urmet CallMe App.
1
2
A
C
B
C
B
3
15