3.1. Key To Symbols; Declaration Of Conformity To The Directive 1999/5/Ec - Urmet 1083/58 Manual De Usuario

1) This device
interference.
2) This device must accept all interference
received, including interference that may
cause undesired operation.
15.105 Information to the user statements:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Plug the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV
technician for help.
RF exposure warning statement
To comply with FCC RF exposure compliance
requirements, a separation distance of at least 20
cm must be maintained between the antenna of
this device and all nearby persons
Changes or modifi cations
approved by the
compliance could void the user's authority to
operate the equipment.

3.1. KEY TO SYMBOLS

Symbol
Direct input voltage
Video door phone system
trademark
20
may not cause
not expressly
party responsible
Description
harmful 4. DECLARATION OF
CONFORMITY TO THE
DIRECTIVE 1999/5/EC
With this document URMET S.p.A. declares that
its Call Forwarding Device for 2Voice system
ref. 1083/58 conforms to the basic requirements
and other relevant provisions set by the Directive
1999/5/EC.
The relevant Declaration of Conformity can be
viewed at www.urmet.com or is available from the
Urmet customer service.
for
For more information scan the QR Code below with
your smartphone or tablet:
http://qrcode.urmet.com/default.aspx?pagUrmet=
sbu2CallForwarding
DS1083-078