Technical Specifications - Urmet 1083/58 Manual De Usuario

4. On your smartphone, open the pedestrian
access door.
5. On the indoor station:
a. a beep
programming has been successfully
completed;
b. to quit the programming mode, hold the
key down for more than 5 seconds.
6. On your smartphone, end the current
conversation.
7. To check the programmed function:
a. lift the handset off the hook at the indoor
station and press the programmed key
(e.g. );
b. check for the presence of the call
on your smartphone and of a voice
feedback when you answer.
B) Programming with handset off-hook.
1. Make a call from the outdoor station to the
indoor station.
2. On your smartphone, answer the call and
leave the conversation open.
3. On the indoor station:
a. hold the door opener button 1 pressed
and lift the handset 2 . A tone coming
from the indoor station will indicate that
programming is in progress.
1
b. now press the button
programmed and wait for a confi rmation
tone from the indoor station.
3
4. On your smartphone, open the pedestrian
access door.
DS1083-078
sound will confi rm
2
3
5. On the indoor station:
a. a
that
b. now hook up the handset of the indoor
6. On your smartphone, end the current
conversation.
7. To check the programmed function:
a. lift the handset off the hook at the indoor
b. check for the presence of the call
For intercom call programming in the
following video door phone models:
mod. Aiko
mod. Modo ref. 1717/12 and 1717/12H
mod. Folio ref. 1706/5 and 1706/6
please refer to the chapter
"(Audio/Video)
door
a record to the directory"
contained in the instruction manual
supplied with the product.
3. TECHNICAL
SPECIFICATIONS
Input voltage from BUS line: ...................... 48 V
External input voltage: .............................. 24 V
Maximum absorption: .............................. 200 mA
Absorbed power in operation: ................ max 6 W
Operating temperature: ........................ -5 ÷ +45 °C
Max humidity: ............................................ 95% RH
Ethernet interface: ............................. 10/100 Mbps
Wi-Fi: ........................................................ 2.4 Ghz
to be
Dimensions (LxDxH):
The product is designed to be
powered off a BUS line or external
power supplies via 24V (6 W, 24 V
terminals, with power supply up to the
specifi ed power source requirements
(LPS) and protected against short
circuits and overcurrents according
to EN 60950-1:2006+A11+A1+A12+A2
provisions.
This device complies with Part 15 of the FCC
rules subject to the following two conditions:
beep sound will
programming has been successfully
completed;
station - which will beep to confi rm
programming mode quitting.
station and press the programmed key;
on your smartphone and of a voice
feedback when you answer.
ref. 1716/1 and 1716/2
Settings
phone directory
(conforms to IEEE 802.11 b/g/n)
with internal antenna
140 (~8 DIN modules) x 90 x 60 mm
confi rm that
\ Video
\ Adding
23 ÷ +113 °F
5.51 x 3.54 x 2.36"
)
19